Removing The Bottom Cover - Christie 4K40-RGB Series Service Manual

3. If required, replace the side-intake cover.
4. To install the side-intake cover, repeat these steps in reverse order, noting the orientation of
the cover.
Ensure that you position the large, unvented portion of the cover adjacent to the back of the
projector.

Removing the bottom cover

The bottom cover provides access to the laser optical subsystem (LOS) and color sensor.
1. Loosen the four captive screws securing the bottom cover.
2. Lower the cover from the projector and slide it out.
If the rigging handles are installed, lift up the top cover to clear the frame, rotate 90 degrees,
and slide the top cover out under the handles.
4K40-RGB Series Service Guide–D4K40-RGB, Roadie 4K40-RGB, Mirage 4K40-RGB
020-102960-02 Rev. 1 (12-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Projector covers
36