Removing The Bottom Cover - Christie DHD410S Service Manual

2. Remove the six captive screws and six hex screws with a Phillips #1 screwdriver securing rear
cover.
3. Remove the rear cover from projector.
4. If required, replace the rear cover.
5. To re-install, follow these steps in reverse order.

Removing the bottom cover

To remove the bottom cover, complete the following steps.
1. Remove the top cover.
See
Removing the top cover
2. Remove the speaker.
See
Replacing the speaker
3. Remove the rear cover.
See
Removing the rear cover
4. Remove the left-side cover.
See
Removing the left-side cover
5. Remove the right-side cover.
See
Removing the right-side cover
6. Remove the main board, audio board and ECPIO board.
See
Replacing the main board
7. Remove the remove the laser driver board.
See
Replacing the laser driver board
8. Remove the combiner module.
See
Replacing the combiner module
9. Remove the light engine.
See
Replacing the light engine
10. Remove front cover.
DHD410S Service Manual
020-001481-01 Rev. 1 (10-2018)
on page 46.
on page 66.
on page 49.
on page 47.
on page 48.
on page 77.
on page 82.
on page 73.
on page 71.
Projector covers
50