Removing The Bottom Cover - Christie GS Series Service Manual

Removing the bottom cover

To re ove the bottom cover
m
1. Remove all covers from the projector.
See Removing the top cover
left-side cover
2. Remove the main board and I/O board.
See Replacing the main board and I/O board
3. Remove fans 4 and 5.
See Replacing fans 4 and 5
4. Remove the complete light engine.
See Replacing the complete light engine
5. Remove the laser driver board.
See Replacing the laser driver board
6. Remove the power supply.
See Replacing the power supply
7. Remove the fan 3.
See Replacing fan 3
8. Remove the elevator feet from the bottom cover.
See Replacing a projector's foot
9. Remove the harnesses from the clips.
10. Remove the 16 M3 screws with a Phillips #1 screwdriver securing the bottom cover.
11. If required, replace the bottom cover.
12. To re-install, follow these steps in reverse order.
GS Series 630-635 Service Manual
020-001224-02 Rev. 1 (08-2018)
complete the following steps.
,
on page 51,
on page 53, and Removing the right-side cover
on page 58.
on page 61.
on page 57.
on page 56.
Removing the rear cover
on page 69.
on page 66.
on page 76.
Projector covers and feet
on page 52, Removing the
on page 54.
55