Temperature Shift - MDT Glass Push Button II Smart Series Technical Manual

Technical Manual Glass Push Button II Smart BE-GT2xx.01

4.3.10 Temperature shift

Function only available for Glass Push Button II Smart with temperature sensor
Two-button function
The temperature shift can be used to move the setpoint of the heating control.
The following figure shows the available settings:
Figure 41: Settings - Temperature shift
The table below shows all available settings:
ETS-Text
Temperature shift
Use internal temperature
Repeated sending at pressed
key
Repetition time
Table 62: Settings - Temperature shift
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
79
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[Default value]
1 Bit temperature shift
1 Byte temperature shift
2 Byte temperature shift
2 Byte shift of basis
comfort setpoint value
not active
active
not active
active
200ms – 3s
[1s]
Comment
Setting how the temperature is
to be shifted
Setting whether the internal
temperature measurement
value is to be used to display
the actual value
Setting whether the shift
should be repeated at fixed
intervals while the key is held
Sets the time between two
telegrams of the temperature
shift when repetition is
activated