Hsv Color Control - MDT Glass Push Button II Smart Series Technical Manual

Technical Manual Glass Push Button II Smart BE-GT2xx.01
Special presentation:
In the special presentation, the status (in percent) is shown on a larger scale on the display. The
following illustrations are possible:
ETS-Text
Special display
Table 53: Special display - Dimming

4.3.7 HSV color control

Single-button function
Two-button function
With the HSV color control, LED dimmers with RGB/RGBW function can be controlled and their status
can be displayed on the display.
The following figure shows the available settings:
Figure 37: Settings - HSV color control
The table below shows all available settings:
ETS-Text
HSV function selection
Table 54: Settings - HSV color control
The HSV color control can control the 3 parameters (hue, saturation, brightness) of the HSV
chromatic circle. A 4 bit dimming command and a switching command are available for the control.
The switching command is used to switch the LED strip on/off. With the 4 bit dimming command, a
cycle through the HSV chromatic circle can be performed. This is a start-stop dimming, that means as
soon as the dimming function becomes active, it will move inside the chromatic circle until the
button is released. After releasing, a stop telegram is sent which terminates the dimming process.
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
72
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[Default value]
bar symbol
bar symbol with fan
value as text (0-100%)
value as text (0-255)
Dynamic range
[Default value]
Hue (H)
Saturation (S)
Value (V)
Comment
At the setti gs ar s
a d ar s ol ith fa , the
corresponding symbol is
displayed and the bar is filled
according to the current status.
With the settings "value as
text" the text is displayed large
on the display.
Comment
Setting of the function to be
controlled
ol