Blind - MDT Glass Push Button II Smart Series Technical Manual

Technical Manual Glass Push Button II Smart BE-GT2xx.01

4.3.5 Blind

Single-button function
Two-button function
The blind function is used to control shutter actuators, which can be used for the adjustment and
control of blinds/shutters.
The following figure shows the available settings:
Figure 32: Settings - Blind
The table below shows all available settings:
ETS-Text
Assignment of push buttons
Operation function
Table 47: Settings - Blind
Two communication objects are displayed for the "blind" function: the object "Stop/slat open/close"
and the object "blinds up/down .
The moving object is used to move the blinds/shutters up and down. The stop/step object is used to
adjust the slats. In addition, this function stops the up/down movement as far as the end position has
not yet been reached.
In the case of the two-button function, the key assignment can be set; the table below shows the
relationships:
Input Push button left
Moving object Up
Stop/Step object Stop/slats open
Table 48: Two-button function - Blind function
The one-button function is used to toggle between the up and down movement after each keystroke.
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
67
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[Default value]
Up/Down
Down/Up
Long=move /
Short=Stop/Slats
Up/Down
Short=move /
Long=Stop/Slats
Up/Down
Function Up/Down
Push button right
Down
Stop/slats close
Comment
Only available at
Two-button function!
Setting the key assignment
(left/right button) for the
up/down function
Setting whether to use a long
key or a short key for
movement
Function Down/Up
Push button left Push button right
Down Up
Stop/slats close Stop/slats open