MDT Glass Push Button II Smart Series Technical Manual page 32

Technical Manual Glass Push Button II Smart BE-GT2xx.01
Communication objects
The following table shows the available communication objects for the appearance of the display:
Number Name
106 Day/Night
107 Presence
112 Time
114 Time/Date
Table 10: Communication objects - Display
After each restart, the day/night object is set to day; even if the communication object is not linked
at all.
The presence object is used to deactivate the display when no one is in the room. It can, for example,
be controlled via a presence detector.
If the presence object is set to the value 0, the display turns off and is only switched on again when
the object is set to 1 or a key is pressed. If a key is pressed with the value 0 (= no presence), the
display remains switched on until the display switches to standby mode. If Standby is deactivated,
the display remains active for 120 seconds.
After each restart, the presence object is set to the value 1 (= presence); even if the object is not
linked.
Attention: The presence object only switches between the conditions "Standby" and "Display off". It
does not switch to normal operation!
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
32
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Lenght Usage
1 Bit Switching between day/night operation
1 Bit Activation/Deactivation of presence
3 Bytes Receiving current time
8 Bytes Receiving current time and date