Settings At The Ets-Software; Commissioning; Reload Symbols - MDT Glass Push Button II Smart Series Technical Manual

Table of Contents

Technical Manual Glass Push Button II Smart BE-GT2xx.01

2.5 Settings at the ETS-Software

Selection in the product database

Manufacturer: MDT Technologies

Product family: Glass Push Button II Smart

Medium type: Twisted Pair (TP)

Product name: addicted to the used type, e.g.: GT2TW.01

Order number: addicted to the used type, e.g.: GT2TW.01

After wiring the device, the assignment of the physical address and the programming of the

application follows:

(1) Connect the interface with the bus, e.g. MDT USB Interface

(2) Set bus power up

(3) Activate the programming mode by pressing buttons 7 and 8 on the device simultaneously,

(Status LEDs on the right and left side of the button alternately flash red)

(4) Loading of the physical address out of the ETS-Software by using the interface (Red LEDs will

turn off as soon as this is successfully completed)

(5) Loading of the application, with requested parameterization

(6) If the device is enabled you can test the requested functions (also possible by using the ETS-

Software)

Any symbols can be loaded into the device. To do this, a DCA app "MDT Glass Push Button II Smart"

has to be downloaded and installed from the MDT website or the my.knx.org shop. The images to be

uploaded must meet the following requirements:

Format: Bitmap

Size: 64x64 Pixel

Color: Black/White

Usage: ETS5 or higher

MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1

Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de

Table of Contents

Show Quick Links

Table of Contents