MDT Glass Push Button II Smart Series Technical Manual page 54

Technical Manual Glass Push Button II Smart BE-GT2xx.01
The table below shows all available settings:
ETS-Text
Switch values
Number of values
Datapoint type
st th
1 – 4 Switching value
Push button long
Left / Right push button: Action
with a long push of button
Action at long push of button
Switching type
Switchover considers status
object
Table 31: "ettings „"end alues - switching values/scenes (up to 4 values)
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
54
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[Default value]
Previous/next
next/previous
2
3
4
DPT 2.001
Switch control
DPT 5.001 Percent
DPT 5.005
Decimal factor
DPT 17.001
Scene number
DPT 9.001 Temperature
DPT 9.004 Brightness
DPT 232.600 RGB value
any value according to the
selected datapoint type
not active
active
st th
1 -4 Switching value
th
4 Switching value if
st
previous was 1 value,
st
otherwise 1 value
Send 0
Off at se o d object
O at se o d o je t
st th
1 -4 Switching value
th
4 Switching value if
st
previous was 1 value,
st
otherwise 1 value
Send 0
Off at se o d o je t
O at se o d o je t
Limit stop
Overrun
Yes
No
Comment
Only available with two-
button function!
Setting to which direction is to
be moved at pressing left/right
buttons
Setting between how many
values should be switched
Sets the data point type to be
sent
Sets the respective value for
the switching value
Activation of a function with a
long keystroke
Only available with two-
button function!
Setting the action with long
keystroke
Only available with single-
button function!
Setting the action with long
keystroke
Only available with two-
button function!
Setting what should happen
when the last switching value is
reached
Setting whether the
changeover should send the
next switching value according
to the current status