Mode Selection - MDT Glass Push Button II Smart Series Technical Manual

Technical Manual Glass Push Button II Smart BE-GT2xx.01

4.3.9 Mode selection

Function only available for Glass Push Button II Smart with temperature sensor
Single-button function
Two-button function
With the function "Mode selection" the HVAC mode can be toggled in heating actuators or
temperature controllers.
The following figure shows the available settings:
Figure 39: Settings - Mode selection
The table below shows all available settings:
ETS-Text
Switching values
Push Button long
Left button: Action at
long push of button
Right button: Action at
long push of button
Action at long push of button
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
76
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[Default value]
Comfort /Standby
Comfort/Night
Comfort/Standby/ Night
Comfort/Standby/
Night/Frost
not active
active
Comfort
Standby
Night
Frost
Comfort
Standby
Night
Frost
Comfort
Standby
Night
Frost
Comment
Setting between which
operating modes can be
toggled.
Activates an action for the long
keystroke
Setting which operating mode
should be called with a long
keystroke to the left button
Only available with two-
button function!
Setting which operating mode
should be called with a long
keystroke to the right button
Only available with two-
button function!
Setting which operating mode
should be called with a long
keystroke
Only available with single-
button function!