Manual Control And Cyclic Send Of The Current State - MDT AMI series Technical Manual

Technical Manual Switch Actuators AMI/AMS
4.3.5 Manual control and cyclic send of the current state
The following illustration shows the available settings for the manual control and the cyclic sending:
Figure 11: Manual control and cyclic send
The following chart shows the dynamic range for this parameter:
ETS‐text
Manual control
Send cyclic the current state
value
Table 16: Manual control and cyclic send
The manual control can be activated or deactivated permanent for each channel, by the settings
"active" or "not active". Additional the manual control can be blocked or enabled via the central
object "manual control". There is only one central object for every channel. This object blocks the
manual control, by a logical "1", at every channel with the setting "activate via object".
The setting "Send cyclic the current state value" activates the cyclic send of the state of the channel
via its status object.
The following chart shows the relevant communication objects:
Number Name
5 State
Manual control
Table 17: Communication objects manual control and cyclic send
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
19
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[default value]

active

not active

activate via object
(Value 1 = not active)

no send cyclic

5min

10min

20min

30min

1h

2h

4h
Length Usage
1 Bit Status object for the corresponding channel
1 Bit blocks the manual control in the channels with
activated function
comment
activates or deactivates the
manual control, also
switchable via the central
object „manual control"
activates the cyclic send of the
current value
If activated, the current state
will be send cyclic at the
adjusted time steps via the
object Channel X: state