Register (Ese); 4Status:operation Register; 5Status:questionable Register - Rohde & Schwarz R&S FSP Series Operating Manual

R&S FSP
5.7.3.4 STATus:OPERation Register
In the CONDition part, this register contains information on which actions the
instrument is being executing or, in the EVENt part, information on which actions the
instrument has executed since the last reading. It can be read using commands
"STATus:OPERation:CONDition?" or "STATus:OPERation[:EVENt]?".
Bit
No.
0
1 to 7
8
9
10
11 to
14
15
5.7.3.5 STATus:QUEStionable Register
This register comprises information about indefinite states which may occur if the
unit is operated without meeting the specifications. It can be queried by commands
STATus:QUEStionable:CONDition?
EVENt]?.
Bit
No.
0 to 2
3
4
5
6
7
8
9
5.24
Meaning
CALibrating
This bit is set as long as the instrument is performing a calibration.
These bits are not used
HardCOPy in progress
This bit is set while the instrument is printing a hardcopy.
This bit is not used
Sweep Break
This bit is set when end of sweep range is reached (spurious measurement, mode analyzer).
Command "INIT:CONM" has to be used to proceed.
These bits are not used
This bit is always 0
Meaning
These bits are not used.
POWer
This bit is set if a questionable power occurs (cf. also section
Register" on page 5.29)
TEMPerature
This bit is set if a questionable temperature occurs.
FREQuency
The bit is set if a frequency is questionable (cf. section
Register" on page 5.26)
This bit is not used.
This bit is not used
CALibration
The bit is set if a measurement is performed uncalibrated (equivalent to label "UNCAL")
LIMit (device-specific)
This bit is set if a limit value is violated (see also section
Register" on page 5.27)
Remote Control – Basics
Status Reporting System
and
STATus:QUEStionable[:
"STATus:QUEStionable:POWer
"STATus:QUEStionable:FREQuency
"STATus:QUEStionable:LIMit<1|2>
Operating Manual 1164.4556.12 - 06