R&S FSP
8 Maintenance and Instrument Inter-
faces
8.1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.1
8.2 Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.2
8.3.1 GPIB Interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.2
The following chapter contains information on the maintenance of the R&S FSP and
on the instrument interfaces:
•
"Maintenance" on page 8.2
•
"Instrument Interfaces" on page 8.2
Please follow the instructions in the service manual when exchanging modules or
ordering spares. The order no. for spare parts can be found in the service manual.
The address of our support center and a list of all Rohde & Schwarz service centers
can be found at the beginning of this manual.
The service manual includes further information particularly on troubleshooting,
repair, exchange of modules (including battery exchange, adjustment of the OCXO
oscillator) and calibration.
Operating Manual 1164.4556.12 - 06
8.3.1.2Bus Lines . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.3
8.3.1.4GPIB Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.4
8.3.3.1Interface Characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.7
8.3.3.2Signal Lines . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.7
8.3.3.5Handshake . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.9
Maintenance and Instrument Interfaces
Introduction
8.1