6Status:questionable:acplimit Register - Rohde & Schwarz R&S FSP Series Operating Manual

R&S FSP
Bit
No.
10
11
12
13 to
14
15
5.7.3.6 STATus:QUEStionable:ACPLimit Register
This register comprises information about the observance of limits during adjacent
power measurements. It can be queried with commands STATus:QUEStionable:
ACPLimit:CONDition? and STATus:QUEStionable:ACPLimit[:EVENt]?.
Bit
No.
0
1
2
3
4
5
6
7
8
9
10
11
Operating Manual 1164.4556.12 - 06
Meaning
LMARgin
This bit is set if a margin is violated (see also section
Register" on page 5.28)
This bit is not used
ACPLimit
This bit is set if a limit for the adjacent channel power measurement is violated (see also
section "STATus:QUEStionable:ACPLimit Register" on page
These bits are not used
This bit is always 0.
Meaning
ADJ UPPer FAIL(Screen A)
This bit is set if in screen A. the limit is exceeded in the upper adjacent channel
ADJ LOWer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the lower adjacent channel.
ALT1 UPPer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the upper 1st alternate channel.
ALT1 LOWer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the lower 1st alternate channel.
ALT2 UPPer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the upper 2nd alternate channel.
ALT2 LOWer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in the lower 2nd alternate channel.
ALT3 to 11 LOWer/UPPer FAIL (Screen A)
This bit is set if in screen A the limit is exceeded in one of the lower or upper alternate channels
3 to 11.
not used
ADJ UPPer FAIL (Screen B)
This bit is set if in screen B the limit is exceeded in the upper adjacent channel.
ADJ LOWer FAIL (Screen B)
This bit is set if in screen B the limit is exceeded in the lower adjacent channel.
ALT1 UPPer FAIL (Screen B)
This bit is set if in screen B the limit is exceeded in the upper 1st alternate channel.
ALT1 LOWer FAIL (Screen B)
This bit is set if in screen B the limit is exceeded in the lower 1st alternate channel.
Remote Control – Basics
Status Reporting System
"STATus:QUEStionable:LMARgin<1|2>
5.25)
5.25