Using The Status Register; Status Registers For Noise Figure Measurements - Rohde & Schwarz R&S FSW-K30 User Manual

®
R&S FSW-K30
Manual operation:

7.20 Using the status register

The status reporting system stores information about the current state of the FSW. This
includes, for example, information about errors during operation or information about
limit checks. The FSW stores this information in the status registers and in the error
queue. You can query the status register and error queue via IEC bus.
The R&S FSW-K30 features several status registers that are specific to "noise figure"
measurements. This chapter describes the application-specific registers, including the
corresponding remote commands.
● Status registers for noise figure

7.20.1 Status registers for noise figure measurements

The figure below shows the status registers of the "noise figure" application.
User Manual 1173.9270.02 ─ 31
Remote control commands for noise figure measurements
See "Search Next Minimum"
measurements....................................................235
Using the status register
on page 106
235