Maintenance; Storing And Packing; List Of Power Cables Available; Instrument Interfaces - Rohde & Schwarz R&S FSP Series Operating Manual

R&S FSP

8.2 Maintenance

8.2.1

Storing and Packing

For the storage temperature range of the R&S FSP, see the instrument specifica-
tions. When stored for an extended period of time the instrument should be pro-
tected against dust.
The original packing should be used, particularly the protective covers at the front
and rear, when the instrument is to be transported or dispatched. If the original pack-
ing is no longer available, use a sturdy cardboard box of suitable size and carefully
wrap the instrument to protect it against mechanical damage.
8.2.2

List of Power Cables Available

Stock No. Earthed-contact connector
DS 006.7013 BS1363: 1967' complying with IEC 83: 1975 standard B2
DS 006.7020 Type 12 complying with SEV-regulation 1011.1059, standard sheet S 24 507
DS 006.7036 Type 498/13 complying with US-regulation UL 498, or with IEC 83
DS 006.7107 Type SAA3 10 A, 250 V, complying with AS C112-1964 Ap.
DS 0025.2365 DIN 49 441, 10 A, 250 V, angular
DS 0099.1456 DIN 49 441, 10 A, 250 V, straight

8.3 Instrument Interfaces

In this section, only a selection of connectors is described:
• "GPIB Interface" on page 8.2
• "Printer Interface (LPT)" on page 8.5
• "RS-232-C Interface (COM)" on page 8.7
For further information on the front and back panel connectors refer to the Quick
Start Guide, chapter 1.
8.3.1

GPIB Interface

The standard instrument is equipped with an GPIB connector. An IEEE 488 interface
connector is located on the rear panel of the R&S FSP. An external controller for
remote control of the instrument can be connected via the IEEE 488 interface con-
nector using a shielded cable.
8.2
Maintenance and Instrument Interfaces
Preferably used in
Great Britain
Switzerland
USA/Canada
Australia
Europe (except Switzerland)
Operating Manual 1164.4556.12 - 06
Maintenance