3Setting The Channel Configuration - Rohde & Schwarz R&S FSP Series Operating Manual

R&S FSP
4.5.13.3 Setting the Channel Configuration
CP/ACP
NO. OF ADJ CHAN
CONFIG
NO. OF TX CHAN
CHANNEL BANDWIDTH
CHANNEL SPACING
ACP REF SETTINGS
CP/ACP (ABS REL)
CHAN PWR / HZ
POWER MODE
ADJUST SETTINGS
Side menu
ACP LIMIT CHECK
EDIT ACP LIMITS
WEIGHTING FILTER
ADJ REFLVL OFFSET
SELECT TRACE
The CP/ACP CONFIG softkey opens a submenu for configuration of the channel
power and adjacent channel power measurement independently of the offered stan-
dards.
The channel configuration includes the number of channels to be measured, the
channel bandwidths (CHANNEL BANDWIDTH), and the channel spacings (CHAN-
NEL SPACING).
Limit values can additionally be specified for the adjacent-channel power (ACP
LIMIT CHECK and EDIT ACP LIMITS) which are checked for compliance during the
measurement.
NO. OF ADJ The NO. OF ADJ CHAN softkey activates the entry of the number ±n of adjacent
CHAN channels to be considered in the adjacent-channel power measurement.
Numbers from 0 to 12 can be entered.
The following measurements are performed depending on the number of the chan-
nels.
0
1
2
3
Operating Manual 1164.4556.12 - 06
!
CLEAR/WRITE
MAX HOLD
Only the channel powers are measured.
The channel powers and the power of the upper and lower adjacent channel
are measured.
The channel powers, the power of the upper and lower adjacent channel and of
the next higher and lower channel (alternate channel 1) are measured.
The channel power, the power of the upper and lower adjacent channel, the
power of the next higher and lower channel (alternate channel 1) and of the
next but one higher and lower adjacent channel (alternate channel 2) are mea-
sured.
Instrument Functions
Analyzer Mode
4.91