3Restrictions; Remote Control In A Network (Lan Interface); 1Setting The Device Address - Rohde & Schwarz R&S FSP Series Operating Manual

R&S FSP
• Before the transition, command processing must be completed as otherwise
transition to remote control is performed immediately
• The keys can be enabled again by sending the control string "@LOC" via RS-
232 (see chapter
Interface (COM)" on page
Via RS-232:
v24puts(port,"@LOC");
Set instrument to manual operation.
5.4.3.3 Restrictions
The following restrictions apply if the unit is remote-controlled via the RS-232-C
interface:
No interface messages, only control strings (see interface description in chapter
"Maintenance and Instrument
page
Only the Common Commands *OPC? can be used for command synchronization,
*WAI and *OPC are not available.
Block data cannot be transmitted.
5.4.4

Remote Control in a Network (LAN Interface)

The R&S FSP can be remotely controlled in a local area network if option B16 (LAN
interface) is installed.
The LAN interface consists of a connector, a network interface card and protocols
(VXI-11 and RSIB). For details on the connector and its use refer to the Quick Start
Guide, chapter 1, "Front and Rear Panel".
Instrument access via VXI11 or RSIB is usually achieved from high level program-
ming platforms by using VISA as an intermediate abstraction layer. VISA encapsu-
lates the low level VXI, RSIB or even GPIB function calls and thus makes the
transport interface transparent for the user. The necessary VISA library is available
as a separate product. For details contact your local R&S sales representative.
5.4.4.1 Setting the Device Address
For control of the instrument in a network, it must be accessed using the preselected
IP address. The IP address of the instrument (device address) is defined in the net-
work configuration.
Setting the IP address:
1. Call SETUP - GENERAL SETUP – CONFIGURE NETWORK menu.
2. Select Protocols tab.
3. Under Properties, set IP address for TCP/IP protocol (for details refer to the Quick
Start Guide chapter 6,
Operating Manual 1164.4556.12 - 06
"Maintenance and Instrument
8.7).
" LAN
Interfaces", section
8.7).
Interfaces", section "RS-232-C Interface (COM)" on
Interface").
Remote Control – Basics
Starting Remote Control
"RS-232-C
5.7