Introduction - Rohde & Schwarz R&S FSP Series Operating Manual

R&S FSP

9.1 Introduction

Error messages are entered in the error/event queue of the status reporting system
in the remote control mode and can be queried with the command SYSTem:
ERRor?. The answer format of R&S FSP to the command is as follows:
The indication of the remote control command with prefixed semicolon is optional.
Example:
The command "TEST:COMMAND" generates the following answer to the query SYS-
Tem:ERRor?:
The subsequent list contains the description of error texts displayed on the instru-
ment.
Distinction is made between error messages defined by SCPI, which are marked by
negative error codes, and the device-specific error messages for which positive
error codes are used:
• 9.2"SCPI-Specific Error Messages" on page 9.3
• "Device-Specific Messages" on page 9.8
The right-hand column in the following tables contains the error text in bold which is
entered in the error/event queue and can be read out by means of query SYSTem:
ERRor?. A short explanation of the error cause is given below. The left-hand column
contains the associated error code.
9.2
<error code>, "<error text with queue query>;
<remote control command concerned>"
-113,"Undefined header;TEST:COMMAND"
Error Messages
Operating Manual 1164.4556.12 - 06
Introduction