Table of Contents
Advertisement
Operation
3.2 Adjusting the separation
separator
adjustment knob
separator pads
rollers
3.3 Loading
side guide adjustment
The illustration to the left shows schematically how
the separation works and the name of the different
parts. Tightening the separator adjustment knob moves
the bearing rollers and the separator pads closer to
the feed belt. Adjust the separation as follows.
Booklets over 3 mm thickness
feed belt
Place the booklet between the bearing rollers and the
feed belt as shown in the illustration. Tighten the
separator adjustment knob until the feed belts move
when the booklet is pulled back and forth.
Single sheets and booklets up to 3 mm thickness
First, place two sheets/booklets between the bearing
rollers and feed belt. Tighten the separator adjustment
knob so the two rollers are parallel. Pull the two sheets/
booklets so they are now between the separator pads
and the feed belts as shown in the illustration. Tighten
the separator adjustment knob. Grab only the top sheet
and keep it streched. Then release until the top sheet
can be pulled out.
Adjustment can be checked from the Module Priority
menu. Press the up arrow button to feed step by step.
To feed an entire set, press the OK button.
Repeat pressing OK while fine turning adjustment if
needed.
Slide the insert side guides away from each other.
Load the inserts. Slide the guides towards and up
against the inserts. First place one insert under the
separation, then load the rest of the stack. Make sure
each insert is up against the front guide.
10
Advertisement
Table of Contents
