Lenovo Flex System Fabric CN4093 Application Manual page 206

4. Turn on VRRP and configure the Virtual Interface Router.
5. Set the priority of Virtual Router 1 to 101, so that it becomes the Master.
6. Configure the ISL ports and place them into a port LAG:
7. Configure the upstream ports.
8. Configure the server ports.
206
CN4093 Application Guide for N/OS 8.4
CN 4093(config)# router vrrp
CN 4093(config-vrrp)# enable
CN 4093(config-vrrp)# virtual-router 1 virtual-router-id 1
CN 4093(config-vrrp)# virtual-router 1 interface 3
CN 4093(config-vrrp)# virtual-router 1 address 10.0.1.100
CN 4093(config-vrrp)# virtual-router 1 enable
CN 4093(config-vrrp)# virtual-router 1 priority 101
CN 4093(config-vrrp)# exit
CN 4093(config)# interface port 4-5
CN 4093(config-if)# switchport mode trunk
CN 4093(config-if)# lacp mode active
CN 4093(config-if)# lacp key 2000
CN 4093(config-if)# exit
Note: In this case, a dynamic LAG is shown. A static LAG could be configured
instead.
CN 4093(config)# interface port 1
CN 4093(config-if)# switchport access vlan 10
CN 4093(config-if)# exit
CN 4093(config)# interface port 2
CN 4093(config-if)# switchport access vlan 20
CN 4093(config-if)# exit
CN 4093(config)# interface port 10
CN 4093(config-if)# switchport access vlan 100
CN 4093(config-if)# exit
CN 4093(config)# interface port 11
CN 4093(config-if)# switchport access vlan 100
CN 4093(config-if)# exit
CN 4093(config)# interface port 12
CN 4093(config-if)# switchport access vlan 100
CN 4093(config-if)# exit