Example 2: Pim-Sm With Static Rp; Example 3: Pim-Dm - Lenovo Flex System Fabric CN4093 Application Manual

Example 2: PIM-SM with Static RP

Example 3: PIM-DM

506
CN4093 Application Guide for N/OS 8.4
The following commands can be used to modify the prior example configuration to
use a static RP:
CN 4093(config)# ip pim static-rp enable
CN 4093(config)# ip pim component 1
CN 4093(config-ip-pim-comp)# rp-static rp-address 225.1.0.0 255.255.0.0
10.10.1.1
CN 4093(config-ip-pim-comp)# exit
Where 225.1.0.0 255.255.0.0 is the multicast group base address and mask, and
10.10.1.1 is the static RP address.
Note: The same static RP address should be configured for all switches in the
group.
This example configures PIM Dense Mode (PIM‐DM) on one IP interface. PIM‐DM
can be configured independently, or it can be combined with the prior PIM‐SM
examples (which are configured on a different PIM component) as shown in
Figure 55.
Note: In the following example, since the receivers and sources are connected in
different areas, the border router must be configured for the IPMC traffic to be
forwarded. Enterprise NOS supports only partial configuration of PIM border
router.
Figure 55. Network with both PIM‐DM and PIM‐SM Components
PIM-SM
Multicast
225.1.0.0/16
IP Interface 11
IP 10.10.1.1
VLAN 101
Component 1
Media
Servers
PIM-DM
Multicast
239.1.0.0/16
PIM Enabled
Lenovo Switch
IP Interface 22
IP 10.10.1.2
VLAN 102
Component 2