Transparent Mode Configuration Example
44
CN4093 Application Guide for N/OS 8.4
This example shows the parameters available for configuration in Transparent
mode:
CN 4093# # easyconnect
Configure Transparent mode (yes/no)? y
Select Uplink Ports (Static Defaults:
The following Uplink ports will be enabled:
Uplink ports(1G/10G):
Select Server Ports (Static Defaults:
The following Server ports will be enabled:
Server ports(1G/10G):
Pending switch configuration:
Uplink Ports:
Server Ports:
Disabled Ports:
Confirm erasing current config to re-configure Easy Connect (yes/no)?
Notes:
If your selection for a port group contains ports of different mode or speed, the
selection is not valid and you are guided to either select other ports or change
the speed of the ports.
If your selection for an uplink port group contains ports of different mode or
speed, the selection is not valid and you are guided to select other ports. Server
ports can have ports of different mode or speed selected at the same time.
You can either accept the static defaults or enter a different port list for uplink
and/or server ports.
17-24)?
17-24
25-64)?
25-64
17-24
25-64
1,5,9,13