Using The Area Id To Assign The Ospf Area Number; Attaching An Area To A Network - Lenovo Flex System Fabric CN4093 Application Manual

Using the Area ID to Assign the OSPF Area Number

Attaching an Area to a Network

474
CN4093 Application Guide for N/OS 8.4
The OSPF area number is defined in the areaid <IP address> option. The octet
format is used to be compatible with two different systems of notation used by
other OSPF network vendors. There are two valid ways to designate an area ID:
 Single Number
Most common OSPF vendors express the area ID number as a single number.
For example, the Cisco IOS‐based router command "network 1.1.1.0
0.0.0.255 area 1" defines the area number simply as "area 1."
Multi‐octet (IP address): Placing the area number in the last octet (0.0.0.n)

Some OSPF vendors express the area ID number in multi‐octet format. For
example, "area 0.0.0.2" represents OSPF area 2 and can be specified directly
on the CN4093 as "area-id 0.0.0.2".
On the CN4093, using the last octet in the area ID, "area 1" is equivalent to
"area-id 0.0.0.1".
Note: Although both types of area ID formats are supported, be sure that the area
IDs are in the same format throughout an area.
Once an OSPF area has been defined, it must be associated with a network. To
attach the area to a network, you must assign the OSPF area index to an IP interface
that participates in the area. The commands are as follows:
CN 4093(config)# interface ip
CN 4093(config-ip-if)# ip ospf area
CN 4093(config-ip-if)# exit
For example, the following commands could be used to configure IPv4 interface 14
for a presence on the IPv4 10.10.10.1/24 network, to define OSPF area 1, and to
attach the area to the network:
CN 4093(config)# router ospf
CN 4093(config-router-ospf)# area 1 area-id 0.0.0.1
CN 4093(config-router-ospf)# area 1 enable
CN 4093(config-router-ospf)# enable
CN 4093(config-router-ospf)# exit
i
CN 4093(config)# nterface ip 14
CN 4093(config-ip-if)# ip address 10.10.10.1 255.255.255.0 enable
CN 4093(config-ip-if)# ip ospf area 1
CN 4093(config-ip-if)# ip ospf enable
Note:
OSPFv2 supports IPv4 only. IPv6 is supported in OSPFv3 (see "OSPFv3
Implementation in Enterprise NOS" on page
<interface number>
<area index>
491).