Loading a New Switch Image
1. Set the FTP/TFTP/SFTP server address where the switch image resides:
2. Set the area where the new image will be loaded:
3. Set the name of the image:
4. If you are using an SFTP/FTP server, enter a username:
5. If you are using an SFTP/FTP server, enter a password:
6. Initiate the transfer. To transfer a switch image, enter 2 (gtimg):
Loading a Saved Switch Configuration
1. Set the FTP/TFTP/SFTP server address where the switch Configuration File resides:
2. Set the name of the configuration file:
3. If you are using an SFTP/FTP server, enter a username:
4. If you are using an SFTP/FTP server, enter a password:
5. Initiate the transfer. To restore a running configuration, enter 3:
574
CN4093 Application Guide for N/OS 8.4
To load a new switch image with the name "MyNewImage-1.img" into image2,
follow the steps below. This example shows an FTP/TFTP/SFTP server at IPv4
address 192.168.10.10, though IPv6 is also supported.
Set agTransferServer.0 "192.168.10.10"
Set agTransferImage.0 "image2"
Set agTransferImageFileName.0 "MyNewImage-1.img"
Set agTransferUserName.0 "MyName"
Set agTransferPassword.0 "MyPassword"
Set agTransferAction.0 "2"
To load a saved switch configuration with the name "MyRunningConfig.cfg" into
the switch, follow the steps below. This example shows a TFTP server at IPv4
address 192.168.10.10, though IPv6 is also supported.
Set agTransferServer.0 "192.168.10.10"
Set agTransferCfgFileName.0 "MyRunningConfig.cfg"
Set agTransferUserName.0 "MyName"
Set agTransferPassword.0 "MyPassword"
Set agTransferAction.0 "3"