Configuration Guidelines; Auto Monitor Guidelines; Manual Monitor Guidelines - Lenovo Flex System Fabric CN4093 Application Manual

Configuration Guidelines

Auto Monitor Guidelines

Manual Monitor Guidelines

© Copyright Lenovo 2017
This section provides important information about configuring Layer 2 Failover.
Note: Auto Monitor and Manual Monitor are mutually exclusive. They cannot
both be configured on the switch.
 Any specific failover trigger may monitor static LAGs only or LACP LAGs only,
but not both.
 All external ports in all static or LACP LAGs added to any specific failover
trigger must belong to the same VLAN.
A maximum of two LACP keys can be added per trigger.

 When VLAN Monitor is on, the following additional guidelines apply:
All external ports in all static or LACP LAGs added to a specific failover

trigger must belong to the same VLAN and have the same PVID.
Different triggers are not permitted to operate on the same VLAN.

Different triggers are not permitted to operate on the same internal port.

For each port in each LAG in a specific failover trigger, the trigger will

monitor the STP state on only the default PVID.
 A Manual Monitor can monitor only external ports.
Any specific failover trigger can monitor external ports only, static LAGs only, or

LACP LAGs only. The different types cannot be combined in the same trigger.
 A maximum of two LACP keys can be added per trigger.
 Management ports, FC ports and stacking ports cannot be monitored.
 Control ports for different triggers must not overlap. Monitor ports may
overlap.
Chapter 33: Layer 2 Failover
521