MSTP Configuration Guidelines
MSTP Configuration Examples
MSTP Configuration Example 1
1. Configure port and VLAN membership on the switch.
2. Configure Multiple Spanning Tree region parameters and set the mode to MSTP.
3. Map VLANs to MSTP instances:
188
CN4093 Application Guide for N/OS 8.4
This section provides important information about configuring Multiple Spanning
Tree Groups:
When MSTP is turned on, the switch automatically moves management VLAN
4095 to the CIST. When MSTP is turned off, the switch moves VLAN 4095 from
the CIST to Spanning Tree Group 128.
When you enable MSTP, you must configure the Region Name. A default
version number of 0 is configured automatically.
Each bridge in the region must have the same name, version number and VLAN
mapping.
This section provides steps to configure MSTP on the CN4093.
CN 4093(config)# spanning-tree mst configuration (Enter MST configuration mode)
CN 4093(config-mst)# name <name>
CN 4093(config-mst)# revision 100 (Define the Revision level)
CN 4093(config-mst)# exit
CN 4093(config)# spanning-tree mode mst (Set mode to Multiple Spanning Trees)
CN 4093(config)# spanning-tree mst configuration (Enter MST configuration mode)
CN 4093(config-mst)# instance <1‐32> vlan <vlan number or range>
(Define the Region name)