L2 Failover With Other Features; Lacp; Spanning Tree Protocol - Lenovo Flex System Fabric CN4093 Application Manual

L2 Failover with Other Features

LACP

Spanning Tree Protocol

520
CN4093 Application Guide for N/OS 8.4
L2 Failover works together with Link Aggregation Control Protocol (LACP) and
with Spanning Tree Protocol (STP), as described in the next sections.
Link Aggregation Control Protocol allows the switch to form dynamic LAGs. You
can use the admin key to add up to two LACP LAGs to a failover trigger using
automatic monitoring. When you add an admin key to a trigger, any LACP LAG
with that admin key becomes a member of the trigger.
Note: If you change the LACP system priority on an LACP aggregation, the
failover trigger goes down.
If Spanning Tree Protocol (STP) is enabled on the ports in a failover trigger, the
switch monitors the port STP state rather than the link state. A port failure results
when STP is not in a Forwarding state (such as Learning, Discarding or No
Link). The switch automatically disables the appropriate internal ports, based on
the VLAN monitor.
When the switch determines that ports in the trigger are in STP Forwarding state,
then it automatically enables the appropriate internal ports, based on the VLAN
monitor. The switch fails back to normal operation.