Redundancy Operations Using The Lbc-4000 Http Interface - Comtech EF Data LBC-4000 Installation And Operation Manual

B.3

Redundancy Operations Using the LBC-4000 HTTP Interface

Chapter 7. ETHERNET INTERFACE OPERATION
Use the LBC-4000 HTTP Interface 'Config | Redundancy' page to configure the LBC-4000's
Redundancy Switch Mode.
Reundancy
Click [Refresh] to update screen.
Name
Redundancy State
Redundancy Mode
Force Backup
Converter A Status
Converter B Status
Appendix B
Figure B-3. 'Config | Redundancy' Page
Use the drop-down menu to select Enable or Disable. Click [Change] to set
LBC-4000 Redundancy operation to this select status.
Use the drop-down menu to select Manual or Auto. Click [Change] to update
LBC-4000 Redundancy operation to this select operating mode.
Use the drop-down menu to select Yes. Click [Change] to force the redundant unit
into standby mode.
This read-only showing Online or Offline.
This read-only showing Online or Offline.
B–5
LBC-4000 L-Band Up/Down Converter System
Description
Revision 6
MN-LBC-4000