Installation; Preparation For Mounting - Siemens SINUMERIK 840D sl Manual

Installation

5.1

Preparation for mounting

Table 5-1
Thanks to the tension jacks on the OP 012, drill-holes or screw holes are not needed.
This retaining method also enables the IP65 degree of protection (but only in conjunction with
a circumferential seal and when the protective USB cap is fitted).
Note
The OP 012 is supplied with what are known as "small" tension jacks. If you have the "large"
tension jacks (6FC5248-0AF06-0AA0) in stock, then you can also use these.
Figure 5-1
Operator panel front: OP 012
Manual, 09/2016, A5E36371591B
Dimensions of the mounting opening
Width (mm)
450
Dimension sheet for installing the OP 012 operator panel front
5
Height (mm)
290
97