BOMBARDIER RALLY 200 2003 Shop Manual page 52

Oil Level
Using the following procedure, check the engine
oil level.
Place the vehicle on a level surface.
NOTE: The engine must be cold, not running.
Unscrew and remove the dipstick then wipe
clean.
Reinstall the dipstick, screw it in completely.
Remove the dipstick and check the engine oil level.
The level should be near or equal to the upper
mark.
1. Full
2. Add
3. Operating range
Oil and Oil Filter Change
WARNING
The engine oil can be very hot. Wait until en-
gine oil is warm.
NOTE: Oil and filter are to be replaced at the same
time. Oil change should be done with a warmed
up engine.
Ensure vehicle is on a level surface.
Clean the drain plug area.
Remove dipstick.
VMR2003_004_02_03A.FM
Section 02 MAINTENANCE
Subsection 03 (MAINTENANCE/LUBRICATION)
Place a drain pan under the engine magnetic drain
plug area.
Clean the magnetic drain plug area.
Unscrew magnetic drain plug.
CAUTION: Pay attention not to lose gasket ring
on magnetic drain plug.
1. Magnetic drain plug
Allow enough time for oil to flow out of oil filter.
Unscrew oil filter cover.
Remove oil filter and replace with a new filter.
Check O-ring on filter cover and change it if necessary.
Check and clean oil filter inlet and outlet area for
dirt and other contaminations.
02-03-3