Section 03 ENGINE
Subsection 11 (CVT)
Place spring no. 25, sleeve no. 26 behind sliding
half and push the centrifugal clutch assembly
no. 18 against driven pulley with clutch holding tool
(P/N 529 035 864).
WARNING
Centrifugal clutch is a spring loaded system.
1. Pushing direction
2. Centrifugal clutch assembly
3. Driven pulley assembly
Installation of Driven Pulley
For installation, reverse the removal procedure.
Pay attention to the following details.
CAUTION: Always use a new spring washer
no. 16 at the time of driven pulley installation.
NOTE: Driven pulley end-play is 0 (zero).
Install clutch holding tool (P/N 529 035 862) to
torque driven pulley nut to 60 N•m (44 lbf•ft).
03-11-11
VMR2003_015_03_11A.FM