BOMBARDIER RALLY 200 2003 Shop Manual page 105

Section 03 ENGINE
Subsection 05 (COOLING SYSTEM)
Using a flat screwdriver, gently pry the block heater
until the glue is braked. Only use the location
showed in the following illustration.
Installation
Remove all residue of glue on the block heater or
on the carburetor body.
Apply 2 ml (.06 oz) of Loctite 384 (P/N 293 800 099)
on the block heater. Spread the Loctite 384 every-
where on the contact surface of the block heater.
03-05-14
Install the block heater in accordance with the fol-
lowing illustration.
Install the block heater lock and torque screw.
Reinstall carburetor. Reverse the removal proce-
dure.
NOTE: Leave the Loctite 384 dries before install-
ing the carburetor on the vehicle. Refer to manu-
facturer instructions.
Check coolant level and refill if necessary.
VMR2003_009_03_05A.FM