Title indicates
main procedure
to be carried-out.
Call-outs for
above illustration.
VMR2003_001_00_02A.FM
Section 03 ENGINE
Ball bearing
must rotate freely. Othewise,
replace it.
Heat up the magneto housing cover to about
o
o
100
C (212
F) for an easy ball bearing removal.
1. Ball bearing
For installation also heat the magneto housing
o
o
up to about 100
C (212
F) to put ball bearing in
place.
Place new ball bearing in freezer for 10 minutes
approximately.
Reinstall other removed parts in the reverse order.
Remove
magneto housing cover
screw
and
stator with trigger coil
.
m
1. Stator
2. Stator screws
3. Trigger coil
4. Trigger coil screws
Check stator and trigger coil condition. If damaged
replace the faulty part.
For electrical inspection, refer to CHARGING SYS-
TEM for the stator and IGNITION SYSTEM for the
trigger coil.
INTRODUCTION
Bold face number
following part
name refers to
exploded view
at beginning of
subsection.
Reference to look
up a certain section
and subsection.
In this case it
concerns
IGNITION SYSTEM.
VII