BOMBARDIER RALLY 200 2003 Shop Manual page 77

SYMPTOM ENGINE DOES NOT START — NO SPARK AT SPARK PLUG (SEE MAGNETO SYSTEM).
CONDITION AT ENGINE CRANKING.
Test/Inspection
VMR2003_006_03_02A.FM
1. Verify spark plug condition.
a. Defective, improperly set, worn out, fouled.
Identify source of problem and correct. Replace spark plug.
2. Verify ignition coil resistance with an ohmmeter.
a. Defective part.
Replace ignition coil.
3. Verify trigger coil resistance with an ohmmeter and connector condition.
a. Defective trigger coil. Corroded connector terminal.
Replace trigger coil. Clean terminals and apply silicone dielectric grease.
4. Verify condition of ignition coil.
a. Mechanically damaged part. Vibration problem. Electrically damaged part.
Replace ignition coil.
5. Verify condition of trigger coil.
a. Mechanically damaged part. Vibration problem. Electrically damaged part.
Replace trigger coil and/or tighten mounting screw(s).
b. Metallic particles caused a short circuit between the soldered connections.
Clean trigger coil from metallic dust.
6. Check magneto for damage and/or electrical failure.
a. Windings of stator have electrical failure (no charging causes an empty battery).
Replace magneto.
Section 03 ENGINE
Subsection 02 (TROUBLESHOOTING)
03-02-17