BOMBARDIER RALLY 200 2003 Shop Manual page 191

1. Gauge tips
2. "L" arm
A. Height
GAUGE ALIGNED WITH MAIN JET
To adjust height, bend the contact tab of float arm
until the specified height is reached.
CAUTION: When adjusting contact tab, do not
pry on. This would apply pressure on needle
and damage valve seat/needle.
VMR2003_017_04_03A.FM
Section 04 FUEL SYSTEM
Subsection 03 (CARBURETOR )
CARBURETOR FLOAT LEVEL ADJUSTMENT
Float level
Installation
To install carburetor on engine, inverse removal
procedure, as described:
Adjust the throttle cable, then install the carbure-
tor cap. Refer to CARBURETOR ADJUSTMENTS
below in this section.
Carefully replace carburetor cap no. 2 in its original
position.
Make sure valve piston no. 5 groove passes the
inside protrusion in carburetor no. 3 before clos-
ing the carburetor cap no. 2.
WARNING
Throttle valve piston groove must be aligned
with carburetor inside protrusion to allow throt-
tle valve piston to reach idle bottom position.
Otherwise throttle valve piston should be half
open leading to potential dangerous situation.
1. Protrusion
2. Valve piston
Reinstall carburetor on engine.
When reinstalling carburetor on engine, pay atten-
tion to the following:
15 mm ± 1mm
(.591 in ± .039 in)
04-03-3