BOMBARDIER RALLY 200 2003 Shop Manual page 178

Section 03 ENGINE
Subsection 11 (CVT)
Measure the roller diameter. If a roller is out of spec-
ification, replace roller kit no. 11.
ROLLER DIAMETER
NEW MINIMUM
NEW MAXIMUM
SERVICE LIMIT
Slider Shoe
Check slider shoes kit no. 13 for visible wear and
replace if damaged or out of specification.
1. Slider shoe
A. Slider shoe gap
1. Slider shoe
2. Ramp plate
3. Lift slider shoes this way
Sliding Half
Check sliding half for cracks and sliding contact
surface for excessive wear. Replace sliding half if
necessary.
Measure bushing diameters of sliding half.
Use a dial bore gauge to measure bushing diame-
ter. Measuring point must be at least 5 mm (1/4 in)
from each bushing edge.
03-11-6
20.00 mm (.787 in)
20.20 mm (.795 in)
19.50 mm (.768 in)
1. Bushing
2. Drive pulley sliding half
A. Bore diameter of bushing
SLIDING HALF BUSHING
NEW MINIMUM
NEW MAXIMUM
SERVICE LIMIT
Replace sliding half if bushing(s) is(are) out of spec-
ification. Visually inspect coatings.
Fixed Half
Check fixed half for scorings and other damages.
If so, replace fixed half.
Check for any marks on fixed half spline. Replace
if necessary.
1. Spline on crankshaft PTO side
2. Drive pulley fixed half spline
26.000 mm (1.024 in)
26.025 mm (1.025 in)
26.100 mm (1.028 in)
VMR2003_015_03_11A.FM