BOMBARDIER RALLY 200 2003 Shop Manual page 86

Section 03 ENGINE
Subsection 04 (REMOVAL AND INSTALLATION)
– clamps retaining the carburetor to the engine
and to the air box
1. Unscrew these clamps
– coolant engine inlet hose
– carburetor no. 3 (place it off to one side)
– carburetor cap
1. Carburetor cap
– exhaust pipe no. 4
(see EXHAUST PIPE further in this section).
03-04-6
From the top side, do the following:
Remove:
– seat (refer to BODY)
– fuel tank (refer to FUEL CIRCUIT).
Unplug the magneto connector.
1. Magneto connector
Remove air box and the air intake hose.
Remove starter.
From bottom side, do the following:
Install engine lifting strap under CVT housing.
1. CVT housing
2. Engine lifting strap
NOTE: Check local specialized supplier to buy an
engine lifting strap.
VMR2003_008_03_04A.FM