Lack Of Power Event; Alarm Generated By Continuous Lack Of Power; Low Battery Alarm Control Panel And Radio Devices; Maintenance Event - urmet domus 1067/032 Programming Manual

3.1.18

Lack of power event

Generated if... •
The event is generated regardless of the system status (24h).
•
Is stored...
•
Is displayed...
•
Is stopped by... •
•
After the mains
return the control •
panel...
•
For more information, see Installation Manual.
3.1.19

Alarm generated by continuous lack of power

•
Generated ...
The alarm is generated regardless of the system status (24h).
activates... •
•
•
Is stored...
Is displayed... •
•
Is stopped by... •
•
5 minutes after the
return of the mains
voltage the control
•
panel...
•
For more information, see Installation Manual.
3.1.20

Low battery alarm control panel and radio devices

Generated if... •
The alarm is generated regardless of the zones system status (24h).
•
activates...
•
Is stored... •
•
Is displayed...
•
When the battery is
charged, the
•
control panel...
•
•
For more information, see Installation Manual.
3.1.21

Maintenance event

generated if... •
•
•
activates...
is signalled... •
inhibits... •
•
•
is stored...
•
is held...
•
For more information, see Installation Manual.
DS1067-035A
the mains voltage is off for a shorter time than the programmed "Lack of power time"
In the event log
by the turnoff of the green LED on the keypads indicating the lack of power presence
by the "POWER" LED on the control panel board, that turns off
the lack of power return
Turns on again the green LED on the keypads indicating the lack of power presence
Turns on the "POWER" LED on the control panel board
stores in the event log the temporary lack of power end
After the Event generated by an lack of power, if the mains voltage fails for a time equal or
longer than the programmed lack of power time
The outputs programmed as Lack of power
the communicator for voice, modem or numerical sending of the respective lack of power
alarm message (if programmed)
In the event log
on keypads, as lack of power event
with the yellow LED on the readers
The mains return for at least 5 consecutive minutes
activates the communicator for voice, modem or numerical sending of the respective event
lack of power alarm message (if programmed)
stores in the event log the lack of power end
deactivates the outputs programmed as lack of power
The control panel battery is flat or absent if the battery of a radio device is acknowledged to
be low.
the outputs programmed as low battery
the communicator for voice, modem or numerical sending of the respective low battery alarm
message (if programmed)
In the event log
By the blinking of the green LED indicating mains presence/battery charging on the keypads
deactivates the outputs programmed as low battery
activates the communicator for voice, modem or numerical sending of the respective event
low battery alarm message end (if programmed)
restore the indication of charged battery on the keypads (green LED on steady)
stores in the event log the low battery condition end
"Maintenance" menu is accessed
maintenance status is activated
the communicator for numerical or modem sending of the respective event Maintenance
message (if programmed)
by maintenance red LED on keypads
alarm outputs
the communicator for vocal, modem or numerical sending of alarm calls
into Event log (start of maintenance)
as long as you are in "Maintenance" menu, provided that maintenance status was not activated
at control panel tamper closing again, provided that maintenance status was activated
17
LBT8633