Table of Contents
Advertisement
4.14 COMMUNICATOR
Warning: information contained in this paragraph assumes that 1067control panel is connected to at least one
PSTN telephone line through 1067/002 communicator and/or one telephone line through 1067/458 interface or
to an ADSL connection through 1067/007interface Ethernet (LAN) – see Installation Manual at paragraph System
Connection Capability.
4.14.1
Telephone credit being used up signalling (for GSM only)
In the presence of GSM communicator (Ref.1067/458) it is possible to receive information about the prepaid SIM residual
credit.
To this aim the 1067/032 or 1067/042 control panel will forward all the SMS messages coming from numbers not known
by the system (these numbers are not included in the list composed by 12 numbers, described below) to the number
stored in position no. 12.
In this way it will possible to receive on your own phone warning messages from the carrier, for example when the credit
decreases under a certain threshold, and other service messages.
To enable this function you need to:
enable GSM telephone line (see § 4.14.22)
enable GSM answer machine (see § 4.14.18)
enable incoming SMS function (see § 4.14.14)
store, into position no. 12, the number of the telephone set on which you want to forward SMSs received
from control panel SIM (see § 4.14.3)
4.14.2
Telephone numbers
1067/032 or 1067/042 control panel communicator can store up to 12 telephone numbers and/or IP addresses; each
number can contain up to 28 digits or pauses, in any configuration.
Each pause lasts 2 seconds; for longer times, put several pauses in sequence. Pauses are entered with ▼ key and are
indicated with a "P" in the display.
Stored telephone numbers can be associated to all the system (the telephone number will be used for any event) or to
zones (the telephone number will be used only for events generated in the specified zones).
It is also possible to choose which telephone network (channel) will use the communicator for external connections:
traditional wired telephone network (PSTN) or mobile network (GSM) or via ADSL (LAN). Of course the choice will be
possible only if both networks are available (connected PSTN telephone line, GSM module inserted and configured,
Ethernet interface connected and configured).
NOTE: if GSM telephone line is used as priority telephone line, it is suggested to enable GSM answer machine; in this
way, GSM module is constantly active and forwarding a call will be in shorter time.
ENTERING IP ADDRESSES
In calls on LAN channel, telephone number corresponds to the fixed IP address of remote PC provided with FastPro.
To enter IP address, following syntax has to be observed:
nnn.nnn.nnn.nnn:ppppp
where: the 12 digits n, separated by a dot in 3-digit groups, correspond to IP address
the 5 digits p correspond to port address
dots "." And colon ":" can be entered by repeatedly and rapidly pressing key 1.
For more information refer to instructions manual Ethernet interface 1067/007 and FastPro SW 1067/001.
DS1067-035A
40
LBT8633
Advertisement
Table of Contents
