Table of Contents
Advertisement
4.15 INSTALLER
4.15.1
Installer enabling
In order to operate on the system, the Installer must be enabled. For security reasons, the Installer enabling expires after
inserting a user or Master code or a Key.
NOTE: at the first system power-on and after every reset, the Installer is automatically enabled.
To enable the Installer follow the instructions below:
1. Enter on the keypad the Master code (default 111111) and press OK key.
2. Press MENU key.
3. Press ▼ key until "ENABLE" appears on the display.
4. Press OK key to confirm.
5. Press OK key to confirm.
6. Press ▼ key to select "ENABLE" and confirm with OK key.
7. Press ESC key repeatedly to exit from the menu.
4.15.2
Installer disabling
The installer is automatically disabled when a User or Master code is entered key, or after inserting a key.
4.15.3
Change code
The Installer can freely change his access code, as described in the following procedure:
1. Enter on the keypad the Installer code (default 000000) and press OK key.
2. Press MENU key.
3. Press ▼ key until "SETTINGS" appears on the display. Press OK key to confirm.
4. Press ▼ key until "CHANGE CODE" appears and confirm with OK key.
5. "NEW" appears. Enter a new code (from 4 to 6 digits) and press OK key to confirm.
6. Enter again the new code to confirm.
7. Press ESC key repeatedly to exit from the menu.
DS1067-035A
55
UT01:MASTER
ENABLE
ENABLE
INSTALLER
INSTALLER
DISABLE
ENABLE
INSTALLER
INSTALLER
ENABLE
UT00:INSTALLER
SETTINGS
SETTINGS
CHANGE CODE
CHANGE CODE
NEW:-------
CHANGE CODE
CONFIRM:
LBT8633
Advertisement
Table of Contents
