Table of Contents
Advertisement
4.10.12 Radio output programming
To program an radio output follow the instructions below:
1.
Enter on keypad the Installer code (default 000000) and press OK key.
2.
Press MENU key.
3.
Press ▼ key until "PROGRAMMING" appears on the display.
4.
Press OK key to confirm.
5.
Press ▼ key until "RADIO DEVICES" appears on the display.
6.
Press OK key to confirm. Select with ▼ keys the radio expansion
7.
Press ▼ key until "SIRENS" appears on the display. Press OK key to confirm.
8.
Select with ▼ key the desired function "SELECT SIREN".
9.
Press OK key to confirm. Select with ▼ key the siren (1058/405).
10. Press OK key to confirm.
11. Press ▼ key until "NAME" appears on the display.
12. Press OK key to confirm.
13. Give the output a descriptive name, by using the keypad (for further information see
§ 4.2).
14. Press OK key to confirm. "NAME" appears.
15. Go back to the upper level by pressing ESC key.
Select the "ASSIGN" function by ▼ and ▲ key, and confirm with OK key.
16. Press OK key to select "SYSTEM" and with ▼ and ▲ keys select "DO NOT
ASSIGN", in order not to associate the output to any zone, or "ASSIGN" to associate
it to all the zones, by confirming selection with OK key.
17. Otherwise it is possible to associate to the output the single zones by pressing ▼ key
until "ZONES" appears.
18. Press OK key to confirm.
19. Select desired zones and press OK key to confirm.
20. Press ESC key until "ASSIGN" appears again.
21. Press ▼ key until "CUSTOMIZE " appears on the display.
22. Press OK key to display the configuration of available outputs. Select desired
configuration with▼ and ▲ keys and confirm it with OK key.
23. Program any other expansion by following the same procedure from point 7.
24. At the end press ESC repeatedly to exit from the menu.
4.11 1058/035 REMOTE CONTROL PROGRAMMING
The flowchart below shows the remote control programming flow once acquired from the 1067 control panel.
In order to allow intuitive and friendly reading of the flowchart, the menu has been represented like it actually appears on
the keypad display, navigation and confirmation keys have also been represented in order to lead the installer step by
step during the programming phase.
For further details concerning the use of the keypad, please refer to the descriptions and drawings contained in
paragraph 2.1 1067/021 Keypad display.
NOTE: function available with 1067 control panel and 1067/021 keypads, software 3.00 or higher and with an 1067/010
radio expansion.
DS1067-035A
37
UT00:INSTALLER
PROGRAMMING
PROGRAMMING
RADIO DEVICES
RADIO DEVICES
EW01:EW01
EW01:EW01
SIRENS
SIRENS
SELECT SIREN
SELECT SIREN
HP01:...
HP01.
U01
NAME
NAME
U01:...
HP01.
U01
NAME
SIRENS
ASSIGN
ASSIGN
SYSTEM
ASSIGN
ZONES
ZN01:...
□□□□□□
SIRENS
CUSTOMIZE
LBT8633
Advertisement
Table of Contents
