Outputs Specialisations - urmet domus 1067/032 Programming Manual

4.7.3

Outputs specialisations

Control panel and expansion outputs, both relay and electric, can be programmed to be activated after specific events.
For more details on single functions, see chapter 3 Alarms, Events and Signalling.
Possible specialisations for outputs are described below.
O BURGLAR
Burglar outputs are armed if an burglar alarm is generated.
O PRE-ALARM
Pre-alarm outputs are armed if a Pre-alarm is generated.
O TAMPER
Tamper outputs are armed if a Tamper alarm or a Wrong code alarm are generated.
O BURGLAR / TAMPER
Burglar/Tamper outputs are armed if a Burglar alarm or a Tamper alarm or a Wrong Code alarm is generated.
O BURGLARY RESET
Burglary Reset outputs are pulse armed for approximately 1 second at zones arming.
O AUDIBLE PANIC
Panic outputs are armed if a Panic alarm is generated.
O SILENT PANIC
Silent Panic outputs are armed if a Silent Panic is generated.
O HOLD-UP
Hold-up outputs are armed if a Hold-up alarm is generated.
O FIRE
Fire outputs are armed if a Fire alarm is generated.
O FIRE RESET
Fire reset outputs are armed if a fire reset input is opened.
O EMERGENCY
Emergency outputs are armed if a Emergency alarm is generated.
O TECHNOLOGICAL TYPE 1 (STATE)
Technological outputs are armed if a Technological event is generated.
O COMMANDABLE
activated if... •
•
•
•
•
•
deactivated if...
O PULSE U COM.
•
activated if...
•
•
•
•
•
is held...
DS1067-035A
an output arm command Is performed by the timing programmer
an arm command via SMS is performed
an output arm command by user remote management Is performed, by entering the correct
DTMF sequence
the control panel is called, by GSM channel, by the telephone number to which the No Cost
Call function has been associated
remote control key "+" is pressed
is performed an output disarm command
an output arm command Is performed by the timing programmer
an arm command via SMS is performed
an output arm command by user remote management Is performed, by entering the correct
DTMF sequence
the control panel is called, by GSM channel, by the telephone number to which the No Cost
Call function has been associated
remote control key "+" is pressed
about 1 second
28
LBT8633