Table of Contents
Advertisement
To configure GSM parameters follow the instructions below:
1. Enter on the keypad the Installer code (default 000000) and press OK key.
2. Press MENU key.
3. Press ▼ key until "TELEPHONE DIALER" appears on the display.
4. Press OK key to confirm.
5. Press ▼ key until "GSM PARAMETERS" appears.
6. Press OK key to confirm.
7. Press OK key. Enter on the keypad the PIN code for the SIM enabling (from 4 to 6
characters) and press OK key to confirm. To delete a PIN code, if the SIM does not require
it, press ESC followed by OK. In this way will appear six dashes instead of digits, whose
meaning is "Not programmed PIN".
8. Press ▼ key until "SIM CARD EXPIRY" appears.
9. Press OK key. Enter expiry month and year (the last 2 digits) and confirm the selection
with OK key. WARNING: it is not possible to change the day.
10. Press ▼ key until "INCOMING SMS" appears.
11. Press OK key. Select with ▼ and ▲ keys if incoming SMS are enabled or disabled for
commandable outputs control and confirm the selection with OK key.
12. Press ESC key repeatedly to exit from the menu.
4.14.15 PSTN line test
1067/032 or 1067/042 control panel can control periodically the PSTN line, by verifying the dial tone, in order to check if
connection is full operating; if it is not operating, it generates a "Telephone Failure" event. This event is generated after 3
unsuccessful consecutive tests.
NOTE: if PSTN line test is enabled, it is encouraged to enable also Tones line check.
Warning: if the control panel, as suggested, is the first device of the telephone line, every line control generates
the interruption of telephone calls, if present, because for each test the control panel gets the PSTN line for some
seconds.
For PSTN line test it is possible to select:
•
Disabled: no PSTN line check (suggested selection if 1067/032 or 1067/042 control panel is connected to a PABX
extension line).
•
24h: PSTN line control is always performed, every 15 minutes, also if the system is disarmed.
•
System ON: telephone line control is always performed, every 15 minutes, only if all configured zones are activated.
To configure the PSTN line test follow the instructions below:
1. Enter on the keypad the Installer code (default 000000) and press OK key.
2. Press MENU key.
3. Press ▼ key until "TELEPHONE DIALER" appears on the display.
4. Press OK key to confirm.
5. Press ▼ key until "PSTN LINE TEST" appears.
6. Press OK key to confirm. Select with ▲ and ▼ keys if the test is disabled or is always
carried out (24 H) or only when the burglar system is armed (SYSTEM ON) and confirm
the selection with OK key.
7. Press ESC key repeatedly to exit from the menu.
DS1067-035A
49
Us00:INSTALLER
TELEPHONE DIALER
TELEPHONE DIALER
PHONE NUMBERS
TELEPHONE DIALER
GSM PARAMETERS
GSM PARAMETERS
SIM PIN
SIM PIN
------
GSM PARAMETERS
SIM CARD EXPIRY
SIM CARD EXPIRY
DATE 01/10/12
GSM PARAMETERS
INCOMING SMS
INCOMING SMS
DISABLE
Us00:INSTALLER
TELEPHONE DIALER
TELEPHONE DIALER
PHONE NUMBERS
TELEPHONE DIALER
PSTN LINE TEST
PSTN LINE TEST
DISABLE
LBT8633
Advertisement
Table of Contents
