Table of Contents
Advertisement
4.16 USERS
4.16.1
User enabling
In order to operate on the system, users must be enabled. According to default settings all users are disabled.
To enable a user follow the instructions below:
1. Enter on the keypad the Master code (default 111111) and press OK key.
2. Press MENU key.
3. Press ▼ key until "ENABLE" appears on the display.
4. Press OK key to confirm.
5. Press ▼ key until "USER" appears and confirm with OK key.
6. Select with ▲ and ▼ keys the user to be enabled confirm the selection with OK key.
7. Press OK key.
8. Select with ▲ and ▼ keys ENABLE and confirm the selection with OK key.
9. Press ESC key to go to the upper level of the menu and follow the same procedure from
step 6 for the other users to be enabled, or press ESC key repeatedly to exit from the
menu.
4.16.2
User disabling
The procedure to disable a user is similar to the user enabling procedure described in paragraph 4.16.1 User enabling.
The only difference consists in selecting "DISABLE" at step 8.
When a user is disabled, his configuration and his parameters are not deleted; these data will be valid again as soon he
will be enabled again. By entering a disabled user code, the access to the menu is forbidden, but this event is not
considered by the counter that generates the wrong code alarm, where present.
4.16.3
How to associate a user to the system
To associate a user to the system (all the zones) follow the instructions below:
1. Enter on the keypad the Master code (default 111111) and press OK key.
2. Press MENU key.
3. Press ▼ key until "SETTINGS" appears on the display. Press OK key to confirm.
4. Press ▼ key until "USERS" appears and confirm with OK key.
5. "CONFIGURE USER" appears. Press again OK.
6. Select with ▲ and ▼ keys the user to be configured and confirm the selection with OK
key.
7. Confirm the selection with OK key.
8. Press OK key.
9. Select with ▲ and ▼ keys "ASSIGN" and confirm the selection with OK key.
10. Press ESC key repeatedly to exit from the menu.
DS1067-035A
56
UT01:MASTER
ENABLE
ENABLE
INSTALLER
ENABLE
USER
USER
UT02:...
UT02:...
ENABLE/DIS USER
ENABLE/DIS USER
ENABLE
USER
UT02:...
UT01:MASTER
SETTINGS
SETTINGS
USERS
USERS
CONFIGURE USER
CONFIGURE USER
UT02:...
UT02:...
ASSIGN
ASSIGN
SYSTEM
SYSTEM
ASSIGN
LBT8633
Advertisement
Table of Contents
