Table of Contents
Advertisement
5.11.5
Global reset
With global reset, all control panel configurations are reset to factory settings (inputs, outputs, zones, timing programmer,
PSTN/GSM telephone parameters) and all previously acquired devices are removed, by replacing respective
configurations with factory settings and deleting the address.
To totally reset follow the instructions below:
1. Enter on the keypad the Installer code (default 000000) and press OK key.
2. Press MENU key.
3. Press ▼ key until "MAINTENANCE" appears on the display.
4. Press OK key to confirm.
5. Press ▼ key until "GLOBAL RESET" appears and press OK key to confirm.
6. Press OK key to confirm or ESC key to undo the operation.
7. "IN PROGRESS..." appears on the display and the buzzer rings.
8. At the end of operation, on keypads appears a row of dots. Turn the system off and start
again from chapter 4 Start-up in the Installation manual.
5.11.6
Backup-Restore
This procedure is already described in paragraph 4.19 Programming by computer.
DS1067-035A
81
UT00:INSTALLER
MAINTENANCE
MAINTENANCE
GLOBAL RESET
GLOBAL RESET
ARE YOU SURE?
GLOBAL RESET
IN PROGRESS...
LBT8633
Advertisement
Table of Contents
