Table of Contents
Advertisement
5.6.4
Commandable outputs activation with no cost
This feature takes advantage of the Caller ID function of the calling telephone to carry out a fast activation of the
programmed commandable outputs.
The control panel must be provided with a GSM module with a valid SIM card, the network and the GSM answer
machine must be enabled.
To the commandable output associated are one or more numbers among the 12 stored telephone numbers.
A user with a known telephone number calls the control panel GSM number and must hang up within 3 rings.
All pulse commandable outputs associated to that number are activated and maintained activated for about one second
(a typical application is remote-controlled gate opener) and all switchable outputs associated to that number are
activated; to deactivate them, send relevant command via SMS.
To confirm that the command with no cost has been received, user receives, from control panel, a call having a duration
of some seconds; user must not answer to this call to prevent it from being charged to control panel SIM manager.
5.6.5
Remote management with vocal menu
The remote management call can be carried out both from a fixed telephone, provided with a DTMF keypad and from a
mobile. To take advantage of all the functions, also PSTN or GSM answer machine and remote disarm must be enabled
(Master menu – Enabling - Advanced).
With remote management it is possible:
•
to arm zones
•
to disarm zones
•
to switch commandable outputs
•
to carry out environmental listening
•
to exclude/include inputs
•
request of system state summary
The system state summary emits vocal messages concerning: active Zones, generic events in Event log, Lack of power ,
Not functioning battery, SIM expiration. Even if present in memory, wrong code events or excluded inputs are not
managed.
*
In remote management "
To carry out the remote management, follow the instructions below:
1. Via a fixed or mobile phone, call control panel telephone number.
2. When it is requested, enter with the keypad a code (master or user) within 10 seconds; after each entered digit wait
for the confirmation beep before entering the next one. When all digits have been entered, enter "#".If the code is
correct, a "Welcome" message will appear, otherwise try to enter again the code (up to a maximum of 3 attempts).
After identification, you have some seconds to enter the digit and directly access the desired menu, otherwise you will
be helped by a vocal menu: follow the instructions to access functions and use them.
3. To exit from remote management press repeatedly "
DS1067-035A
(menu digit: 0)
(menu digit: 1)
(menu digit: 2)
(menu digit: 3)
(menu digit: 4)
(menu digit: 9)
" key (asterisk) allows to go back to the previous menu.
*
" key.
75
LBT8633
Advertisement
Table of Contents
