Table of Contents
Advertisement
4
SYSTEM START-UP
In this chapter are described the necessary programming procedures for 1067 system start-up, after installation of the
physical devices.
4.1
SYSTEM ACCESS CODES
For 1067 system management it is possible to use up to 32 different access codes: 1 Installer code, 1 Master code and
30 User codes. The access code can be freely programmed, from a minimum of 4 digits up to 6 digits max. According to
its type, the code allows specific system functions. Every user can change its own access code as he wants; the system
will automatically assign him a code for hold-up function; this new code is the same as the previous + 1 (for example: if I
choose 789456, the hold-up code will be 789457).
Suggestion: every user, included Master and Installer, should change their code before the system start-up.
The Master code is always enabled and it is the only code authorized to enable the other codes; it can also reset the
other access codes to the factory value (if someone forgets them).
The entered access code must be confirmed by pressing OK key.
Warning: if any user enter his code, the Installer that might be enabled will automatically be disabled; he is also
disabled after electronic or proximity key insertion.
4.1.1
Default codes
Code type
Installer
Master
User (2 ÷31)
The control panel installer code is enabled by default; the code is automatically disabled after entering for the first time a
new valid code.
4.1.2
Access to functions
The various functions of system 1067 are collected into 4 separate Menus:
FREE ACCESS MENU
Directly accessed by pressing MENU key without entering any codes and including following functions:
•
Displaying failures
•
Displaying Timing Programmer preinsertion status
•
Displaying open inputs list
•
Displaying excluded inputs list (followed by entry code)
•
Looking in Alarm Memory
•
Looking in Tamper Memory
•
Setting "Info display" wording being displayed in rest conditions (followed by entry code)
•
Regulating buzzer volume
•
Regulating display contrast
•
Regulating display back light
DS1067-035A
Default code
000000
111111
000020-000310
19
Associated zones
All
All
Programmable
Enabled
Yes
Yes
No
LBT8633
Advertisement
Table of Contents
