Table of Contents
Advertisement
4.14.3
Telephone number storing
To store a telephone number follow the instructions below:
1. Enter on the keypad the Master code (default 111111), or the Installer code (default
000000), and press OK key.
2. Press MENU key.
3. Press ▼ key until "TELEPHONE DIALER" appears on the display
4. Press OK key to confirm.
5. Press OK key to confirm.
6. Press OK key to confirm.
7. Select with ▲ and ▼ keys the memory location to be used and confirm selection with OK
key. The display cursor blinks.
8. Enter the telephone number. To rectify a digit, position the cursor on it using keys ◄ and
► and overwrite it. To delete the number, press ESC key. Press OK key to store
entered number.
9. If you have to store another telephone number, select with ▲ and ▼ keys the memory
location to be used and confirm selection with OK key. Then repeat step 8.
10. Press ESC key to go back to the upper level of the menu.
11. Press ▼ key until "ASSIGN TEL N." appears on the display.
12. Press OK key to confirm.
13. Select with ▲ and ▼ keys the telephone number to be associated and confirm selection
with OK key
14. Select with ▲ and ▼ keys if the telephone number must be associated to "SYSTEM" or
to "ZONES" and confirm selection with OK key.
15. If "SYSTEM" has been selected, choose between "ASSIGN" and "DO NOT ASSIGN" and
confirm with OK key. If "ZONES" has been selected, it is necessary to select before the
zone with ▲ and ▼ keys and OK key and then choose between "ASSIGN" and "DO NOT
ASSIGN"; to the same telephone number can be associated several zones.
16. Press ESC key to go back to the upper level of the menu. If another number must be
associated, repeat from step 13.
17. Press ESC key to go back to the upper level of the menu.
18. Press ▼ key until "PHONE LINE" appears on the display.
19. Press OK key to confirm.
20. Select with ▲ and ▼ keys the telephone number to be configured and confirm the
selection with OK key.
21. Press OK key to confirm.
22. Select with ▲ and ▼ keys if the telephone number must be associated to PSTN network,
to GSM network or LAN network (it is possible only if in the control panel is installed the
GSM module interface and/or LAN). This programming procedure specifies on which
telephone network (PSTN,GSM and/or LAN) will be dialled this number. If more networks
are enabled, the network associated here will be the master "channel". IP addresses are to
be associated to LAN network. Telephone networks associated to the single numbers must
be enabled in advance (see § 4.14.22). If a telephone number is associated to a disabled
network, no calls will be sent to that number.
Confirm selection with OK key.
23. Press ESC key to go back to the upper level of the menu. If another number must be
associated, repeat from step 20.
24. Press ESC repeatedly to exit from the menu.
DS1067-035A
41
UT01:MASTER
TELEPHONE DIALER
TELEPHONE DIALER
PHONE NUMBERS
PHONE NUMBERS
TEL.NUMBER
TEL.NUMBER
T01:
TEL.NUMBER
T01:■
PHONE NUMBERS
ASSIGN TEL N.
ASSIGN TEL N.
T01:xxxxxxxx
T01:xxxxxxxx
SYSTEM
PHONE NUMBERS
ASSIGN TEL N.
PHONE NUMBERS
PHONE LINE
PHONE LINE
T01:xxxxxxxx
T01:xxxxxxxx
SELECT LINE
SELECT LINE
PSTN LINE
LBT8633
Advertisement
Table of Contents
