1 Introduction
The EC type approval certificate is:
The corresponding conformity certificates are provided in the annex. The RMG con-
18
tact information is provided on the second and last page.
1.3.4.1.
The TME400-VM and TME400-VMF can be supplied with DIN and ANSI connec-
tions. Up to nominal diameter DN 200, the installation position of the turbine meter
with permanent lubrication can be selected as required. From nominal diameter
DN 250, the meter must be installed in the ordered installation position. It must also
be ensured that the filling opening of the lubrication faces upwards.
1.3.4.2.
The turbine meter TME400 in standard version is approved for the following tempera-
ture ranges.
Temperature ranges
Medium temperature
According to ATEX (T
According to PED 2014/68/EU
Pressure safety for DN25 according
to sound engineering practice, see
PED 2014/68/EU, sec. 4, subsec. 3
Lower temperature limits are available on request with the welded version and round steel material.
Caution
Direct solar radiation must be avoided.
Manual TME400-VMF · EN07 · December, 7
TÜV 17 ATEX 207566 X
IECEx TUN 18.0009 X
Installation and mounting position
Temperature ranges
)
amb
th
2020
-25°C to +55°C
-25°C to +55°C (II 2G Ex ia IIC T4)
-20°C to +80°C (spheroidal graphite iron)
-40°C to +80°C (cast steel)
-40°C to +80°C (stainless steel)
-10°C to +80°C (welded version
and round steel material)
-40°C to +60°C (aluminum)